The way this works is that MIDI messages coming into MIDITrack1 will be sent to AudioTrack1 and since Amplitube is the only device loaded under AudioTrack1, it will receive the messages. Set the monitor for the AudioTrack1 to "Auto" (this step is technically not required).Change the "MIDI To" dropdown of MIDITrack1 to AudioTrack1.Create a new MIDI track that will act as the "router" for the message from FCB1010 to the Amplitube VST.Add the Amplitube VST to an empty audio track - call this AudioTrack1.So I opened up Ableton Live and then started routing the messages by doing the following: With the above scenario set up, you would think that all you could have to do to control the preset using Ableton Live is to route the MIDI messages from the FCB1010 to the Amplitube VST. When I have Amplitube running as a standalone, and set the FCB1010 as my MIDI device under settings, hitting the button on the FCB1010 changes the preset to Blues Drive successfully.
#How to input to ik amplitube windows 10 Pc
I have an FCB1010 controller that I have programmed to send PC 1 on channel 8 when I press a button. This is also in the MIDI settings but under the Global tab. The global receive channel for Amplitube must be the same as the channel on which the PC messages are being sent. So I have set my preset called "Blues Drive" to be activated by PC 1.
In Amplitube, if you click the little MIDI button on the bottom right and go to the Preset tab, you can change which PC message (PC 1, PC 2, and so on) the currently selected preset will be activated by.
To change an Amplitube preset, a MIDI Program Change (PC) message must be sent to it. This sounds fairly simple, but I found a few things have to be set before this will work: Other VSTs work just fine in the same fashion, just Amplitube doesn't work.īasically, I want to control Amplitube VST using Ableton Live by routing the MIDI messages from a MIDI controller to the Amplitube VST. Also, when I open up the Amplitube standalone application, things work just fine. The scenario I'm about to describe used to work flawlessly without any hitches, but for some reason a few months ago it stopped working. I have been dealing with this problem for a few months now without any success and I was wondering if anyone has ran into this issue.